Search results for "Flat band potential"
showing 4 items of 4 documents
The influence of composition on band gap and dielectric constant of anodic Al-Ta mixed oxides
2015
Al-Ta mixed oxides were grown by anodizing sputter-deposited Al-Ta alloys of different composition. Photocurrent spectra revealed a band gap, Eg, slightly independent on Ta content and very close to that of anodic Ta2O5 (∼4.3 eV) with the exception of the anodic film on Al-10at% Ta, which resulted to be not photoactive under strong anodic polarization. The photoelectrochemical characterization allowed to estimate also the oxides flat band potential and to get the necessary information to sketch the energetic of the metal/oxide/electrolyte interfaces. Impedance measurements allowed to confirm the formation of insulating material and to estimate the dielectric constant of the oxides, which re…
Corrosion behaviour of a highly alloyed austenitic alloy UB6 in contaminated phosphoric acid
2013
The influence of temperature (20–80°C) on the electrochemical behaviour of passive films anodically formed on UB6 stainless steel in phosphoric acid solution (5.5 M H3PO4) has been examined by using potentiodynamic curves, electrochemical impedance spectroscopy, and Mott-Schottky analysis. UB6 stainless steel in contaminated phosphoric acid is characterised by high interfacial impedance, thereby, illustrating its high corrosion resistance. The obtained results show that the films behave as n-type and p-type semiconductors in the potential range above and below the flat band potential, respectively. This behaviour is assumed to be the consequence of the semiconducting properties of the iron …
Photocurrent spectroscopy in passivity studies
2018
The aim of this article is to present photocurrent spectroscopy as useful in situ technique for the physicochemical characterization of passive films and corrosion layers. The response of (both amorphous and crystalline) semiconductor/electrolyte junction under irradiation is treated and discussed in order to get information about solid-state properties such as band gap and flat band potential. The possibility to use Photocurrent Spectroscopy (PCS), in a quantitative way, to get information on the composition of corrosion layers is discussed through a semiempirical correlation between the band gap of the oxides (or hydroxides) and the difference of electronegativity of their constituents. F…
Influence of the electrodeposition conditions on the energetics of polypyrrole thin films
2008
The influence of the solvent used for the electrodeposition and that of the dopant anion on the energetics of electrochemically grown polypyrrole were studied by means of a non-destructive optical technique: Photocurrent Spectroscopy. Polypyrrole films doped with the same anion and grown in different solvents, both aqueous and non- aqueous, show the same HOMO-LUMO gap and the same Fermi level location in respect to HOMO. Polypyrrole films doped with different anions in aqueous solutions, present different values of indirect band gap and flat band potential, indicating that dopant anion influences both the defects band and the Fermi level locations.